Advanced Setup - ECS G45T-M2 Manual

32

Advanced Setup

This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Thermal Management
TM Status
Limit CPUID MaxVal
Enhanced Halt (C1E)
Intel XD Bit
Intel EIST
Intel Virtualization Technol
Quick Power on Self Test
Boot Up Numlock Status
APIC Mode
1st Boot Device
2nd Boot Device
3rd Boot Device
Hard Disk Drives
Removable Drives
Boot Other Device
Thermal Management/TM Status (Enabled/TM1/TM2)
These items display CPU's temperature and enable you to set a safe temperature to
Prescott CPU.
Limit CPUID MaxVal (Disabled)
This item can support Prescott CPUs for old OS. Users please note that under NT
4.0, it must be set "Enabled", while under WinXP, it must be set "Disabled".
Enhanced Halt (C1E) (Enabled)
This item enables or disables enhanced halt (C1E).
Intel XD Bit (Enabled)
This item allows users to enable or disable the Intel XD bit.
Intel EIST (Enabled)
This item allows users to enable or disable the EIST
technology.
Intel Virtualization Technol (Enabled)
Hardware Virtualization Technology enables processor feature for runningmultiple
simultaneous Virtual Machines allowing specialized softwareapplications to run in full
isolation of each other.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
Advanced Setup
Enabled
TM1/TM2
Disabled
Enabled
Enabled
Enabled
Enabled
Enabled
On
Enabled
Hard Disk Drive
CD/DVD
1st FLOPPY DRIVE
Press Enter
Press Enter
Yes
: Move Enter : Select
+/-/: Value
F10: Save ESC: Exit
F1: General Help
F9: Load Default Settings
Using BIOS
Help Item
For the processor its
CPUTD belows 0F41h.
TM2 only can be enable
under below settings.
1.Freq.>=3.6GHz FSB800
2.Freq.>=2.8GHz FSB533
Enhanced Intel SpeedStep
(