ECS G45T-M2 Manual page 37

APIC Mode (Enabled)
This item allows you to enable or disable the APCI (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
1st/2nd/3rd Boot Device (Hard Disk Drive/CD/DVD/1st FLOPPY DRIVE)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
Hard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Hard Disk Drives
1st Drive
: Move Enter : Select
F1: General Help
Press <Esc> to return to the Advanced Setup page.
Removable Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Removable Drives
1st Drive
: Move Enter : Select
F1: General Help
Boot Other Device (Yes)
When enabled, the system searches all other possible locations for an operating
system if it fails to find one in the devices specified under the First, Second and Third
boot devices.
Press <Esc> to return to the main menu setting page.
Hard Disk Drives
WDC WD1600JS-22NCB1
Specifies the boot
sequence from the
available devices.
+/-/: Value
F10: Save ESC: Exit
F9: Load Default Settings
Removable Drives
1st FLOPPY DRIVE
Specifies the boot
sequence from the
available devices.
+/-/: Value
F10: Save ESC: Exit
F9: Load Default Settings
Using BIOS
33
Help Item
Help Item