Maintenance - Dimplex DF3215 Owner's Manual

! NOTE: To temporarily unlock the remote transmitter press (in
order) I - Temperature Down then J - Temperature Up then K -
Dimmer Down/Firelight Off.
When the remote transmitter's backlight is illuminated the Child Lock
is bypassed. When the backlight is off the Child Lock is re-activated.
Frequency Interference
If the fireplace does not respond properly to the remote control, the
remote operating frequency may have to be reset. The remote control
can send another frequency code to the circuit board to eliminate
interference.
1. Simultaneously press the O - Slow Start/Fading Embers Off
button and the Q - Purifire™ Low Speed button on the remote
control.
2. "CODE" will appear.
3. Release the Slow Start/Fading Embers Off button and the
Purifire™ Low Speed button.
4. Press and hold the Initialization Button on the unit (Figure 4).
5. Press the G - Flame & Heat On/Off button on the remote and
release the Initialization Button.
Your remote will now have a different frequency communicating with
the fireplace.

Maintenance

WARNING: Disconnect power before attempting any maintenance
or cleaning to reduce the risk of fire, electric shock or damage to
persons.
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool before touching
bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of
the flame or when the clarity and detail of the log ember bed exterior
disappears. There are four (4) bulbs under the log set, which generate
the flames and embers, and two (2) bulbs above the log that illuminate
the log exterior.
16