Output - dbx DriveRack 260 User Manual

DriveRack
Section 4 ®
Detailed Parameters
Input 1 Level -Inf to 20dB
Adjusts the input level of input 1.
Input 2 Level -Inf to 20dB
Adjusts the input level of input 2.
Master level -Inf to 20dB
This parameter is used to control the overall level of the mixed input signals.
Pink Noise On/Off
Turns the pink noise generator on and off.
Noise Level -20 to 20
Adjusts the overall level of the pink noise generator.

4.12 Output

The output section of the DriveRack 260 provides the user with the ability to control output
levels of the unit and adjust phase compensation of loudspeakers within the signal path. The
output level control is located in the signal path before the limiters; this means that the limiter
directly affects the output level. The parameters for the Phase/Polarity Compensation effect are
as follows and are user adjustable. Please refer to section A.7 of the Appendix for a complete
output signal routing diagram.
Shift On/Off
This parameter is used to turn the selected output phase parameters on or off. When Shift is
off, phase is 0 and polarity is positive (+).
0
Polarity +/-
This parameter is used to reverse the polarity of the output signal.
Phase 0 to -175 Degrees
This parameter is variable in 5 degree increments and sets the amount of phase shift within the
selected output path. The phase is referenced to the upper frequency of the selected output
crossover band.
38 DriveRack® User Manual