DriveRack
To set the PUP Program option use the following procedure:
From Program mode, press the UTILITY button and use the PREV PG or NEXT PG
•
buttons to move to the page that appears as follows:
10
RTA
With the arrow next to the PUP Program option, turn the DATA wheel to make the
•
desired selection.
To change the PUP Mute setup, use the following procedure:
From Program mode, press the UTILITY button and use the PREV PG or NEXT PG
•
button to move to the page that appears as follows:
10
RTA
Select the PUP Mute option by pressing the DATA wheel until PUP Mute is selected.
•
Once the PUP Mute option has been selected, proceed to rotate the DATA wheel until
the desired mute setting is selected. To exit, press the PROGRAM/CONFIG button.
A unique feature of the DriveRack 260 is its ability to interface with dbx proprietary Zone
Controller wall-panels. This feature gives you the ability to control various parameters of
the 260 such as Output Levels, Mute and Program Changes. Up to six ZC panels can be
connected to a DriveRack 260. To program a ZC panel, proceed with the following instructions.
From Program mode, press the UTILITY button and use the PREV PG or NEXT PG
•
button to move to the page that appears as follows:
Stored
Current
Important Note: The dip switches on the ZC panel(s) must match the Panel (ID) number
displayed in this page.
®
Power Up Modes
PUP Program
PUP Mute
Power Up Modes
PUP Program
PUP Mute
ZC Setup
Panel 1
(STORE) - EDIT PANEL
Panel 1
Boost 0dB Cut
Output
1
2
Utilities/Meters
Stored
Current
Stored
Current
None
ZC-2
0dB
3
5
DriveRack® User Manual
4
6
Section 5
ZC Setup
Panel 1
(STORE) - EDIT PANEL
Panel 1
Boost 0dB Cut
Output
1
3
2
4
ZC Setup
Panel 1
Panel 1
Select A
No Change
(STORE) - EDIT PANEL
Panel 1
Panel 1
Switch
1
2
Boost 0dB Cut
No Change
Output
1
3
5.1.3 ZC Setup
2
4
Panel 1
Select A
No Change
Set Security Level
Pre EQ
Low
Panel 1
Switch
1
2
No Change
41
None
ZC-2
0dB
5
6
ZC-3
None
ZC-4
ZC-2
3
4
0dB
5
6
ZC-3
ZC-4
3
4