Preset Programs; Before You Start - Danfoss TP5000 si range Installation And User Instructions Manual

Weekdays (Mon-Fri)
Event Time
1 06:30
2 08:30
3 11:30
4 13:30
5 16:30
6 22:30
Note: these are also times for
Block "A" programmes
Note: If set up for 4 events per day, events 3 & 4 are skipped. If set up for
2 events per day, events 2, 3, 4 & 5 are skipped. In both cases the events
are re-numbered.

Before you start

Open the fl ap on the front of the programmer and
press the RESET button with a non-metallic object
until the display goes blank. This will ensure that
the micro-computer in the product is operating
correctly.
Customising the display
For the sake of clarity, the instructions assume that the display setting
uses a 24 hour clock, °C and that days of the week are shown as text.
All of these settings can be personalised after the thermostat has been
programmed, see pages 22 - 24.
Setting the correct date and time
Your TP5000 Si incorporates a real time clock with calendar function that
automatically changes time in both Spring and Autumn. The time and
date is set in the factory for the UK time zone, and does not normally
require adjustment. If you live in another time zone refer to "Time zone
off set" on page 26. However, should it be found necessary to adjust
time or date for any other reason refer to the following instructions.
Temp. °C Event
20
15
20
15
21
15
Weekend (Sat-Sun)
Time
1 07:30
2 09:30
3 11:30
4 13:30
5 16:30
6 22:30
Note: these are also times for
Block "B" programmes
GB
Temp. °C
20
20
20
20
21
15
RESET
17