Setting The Clock; Running Your Programme; Before You Change The Preset Programmes - Danfoss TP4000 Installation Instructions Manual

Setting the Clock

Note: clock is displayed in 24 hour mode.
CLOCK
Press PROG and Λ to begin programming.
Use + or - to adjust the TIME (press and hold to
change in 10 min increments).
Press PROG to enter the TIME.

Running your programme

If you are happy to use the preset programmes on
page 6, you don't need to do anything else.
Your unit is now in RUN mode.

Before you change the preset programmes

Please Note
The unit must be programmed in sequence. Event times cannot be
programmed out of sequence.
If you want to leave a preset time as it is, simply press PROG to move
on to the next setting.
During programming, if no buttons are pressed for 2 minutes the unit
will automatically return to RUN mode, and the programme set up to
that minute will be active.
GB
7