6.Selective Calling
6.1.3 Switching Off the Tone Squelch
Select TN-OFF in the menu 12 of the Set mode, and press any key other than the
MONI or FUNC key to complete setting.
6.1.4 To Differentiate the ENC/DEC Tones
To set the encoding and decoding tones independently, perform the following settings.
1. To set the encoding tone, while
key to move to the menu 13 and select a desired encoding tone by rotating the dial.
2. Press the MONI key to go back to the menu 12 then rotate the dial clockwise to
select TN-TSQ. Press the FUNC key to move to the menu 13 again and select a
desired decoding tone frequency using the dial.
3. Press the PTT key to return to the operating mode or the FUNC/MONI keys to
continue with setting programming in the Set mode.
6.1.5 Tone Squelch Operation
The squelch unmutes only when the signal with the same decoding-setting tone is
received.
6
6.2
DCS
6.2.1 Setting the DCS
1. Select the menu 14 in the Set mode to display the current DCS setting. The initial
setting is DCS-OF.
Rotating the dial, the display switches between:
2. Press any key other than the MONI or FUNC key to complete the setting. Observe
that "
38
DCS-OF
" is displayed.
is displayed in the setting menu 12, press the FUNC
DCS
DCS
023
754