Adjusting The Cycles Per Hour - Carrier 33CS420-01 Owner's Manual

Adjusting the Cycles Per Hour

Adjusting the Cycles Per Hour
The Cycles Per Hour setting may limit the number of times per hour
your HVAC unit may energize. For example, at a setting of 6 cycles
per hour the HVAC unit will only be allowed to energize once every 10
minutes. The Cycles Per Hour limit may be overridden and reset by
pressing the UP or DOWN buttons on the thermostat.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
Select the cycles per
hour limit.
d=cycles per hour
limit defeated.
13
d1=d + defeat 5 min.
compressor lockout.
(d1, d, 2 - 6)
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
I9
6
Setup
Cy
Page 13.3
Carrier
MODE
MODE
Press
PROGRAM