Programming A Security Level - Carrier 33CS420-01 Owner's Manual

Programming a Security Level

Programming a Security Level
When a security level has been programmed, the thermostat will allow
limited adjustment to the setpoints (steps #7 and 8). In security
levels 2 and 3, the thermostat is forced into the Program On mode.
To disable the security feature, set the value in step #6 to 0; this will
cause steps # 7 and 8 not to appear.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
8
Press the MODE button repeatedly
MODE
until this setup screen appears.
Select the security level:
0=No security in effect
1=Setpoint range limited
2=1+ program on all times
3=2 + prohibits setpoint
changes
Step #7 appears only
if step #6 is not 0.
Adjust the maximum
allowable heat setpoint
when security is in effect.
(35 - 99 )
Step #8 appears only
if step #6 is not 0.
Adjust the minimum
allowable cool setpoint
when security is in effect.
(35 - 99 )
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
6
0
Setup
7
80
Setup
H
I
H
EAT
8
65
Setup
C
OOL
L
O
Page 8.4
Carrier
MODE
MODE
Press
MODE
Press
MODE
Press
PROGRAM