Page of 8
Download Bookmark Comment

Carrier DEBONAIR 33CS Owner's Manual

Carrier thermostat user manual.
IMPORTANT: Read entire instructions before program-
ming the thermostat.
GENERAL
The commercial, programmable thermostats are wall-
mounted, low-voltage thermostats which maintain room tem-
perature by controlling the operation of an HVAC (heating,
cooling and ventilation) system. Separate heating and cool-
ing set points and auto-changeover capability allow occu-
pied and unoccupied programming schedules for energy savings.
All thermostats allow up to 3 occupied and one unoccu-
pied time/temperature setting to be programmed per 24-hr
period. Each thermostat stores programs for 3 different days
(Saturday, Sunday, and Monday through Friday). Batteries
are not required. During power interruption the internal
NEVERLOST™ memory stores programs for an unlimited
time.
CONFIGURATION
Thermostat Display —
cated in the center of the thermostat. See Fig. 1. The fol-
lowing information can be displayed on the screen:
• mode (OFF, HEAT, COOL, AUTO, or PROGRAM ON)
• fan setting (FAN ON or blank)
• override indication
• room temperature
• desired temperature
• time of day
• day of the week
• schedule period (Occupied 1, 2, or 3; or Unoccupied)
• setup indicator (programming mode)
• lock indicator
• start/stop indicator (schedule period program mode)
Heat or Cool Indicator —
located on the bottom middle cover of the thermostat. See
Fig. 2. The light will be red if the thermostat is in Heating
mode. The light will be green if the thermostat is in Cooling
mode.
Thermostat Front Panel Buttons —
stat has buttons on the front cover which are used to raise or
lower the desired set point and override the current program.
See Fig. 2.
SET POINT BUTTONS — The UP ARROW and DOWN
ARROW buttons will raise or lower the current desired tem-
perature set point. If the thermostat is in AUTO mode, press-
ing the UP ARROW or DOWN ARROW button will adjust
both the heating and cooling set points. Pressing the UPAR-
ROW or DOWN ARROW button in Cooling mode will ad-
just only the cooling set points. Pressing the UP ARROW or
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Book 1
4
PC 111
Tab
11a 13a
Owner's Manual
Part Number 33CSSP2-WC
The thermostat display is lo-
A Heat or Cool indicator is
The thermo-
Catalog No. 533-347
Printed in U.S.A.
Programmable Thermostat
DOWN ARROW button in Heating mode will adjust only
the heating set points. The UP ARROW and DOWN AR-
ROW buttons are also used in Programming mode.
OVERRIDE BUTTON — The Override button is used to
force the thermostat from Unoccupied mode into the Occu-
pied 1 mode comfort settings. The Override period will be
set at 30 minutes. The thermostat will then return to Unoc-
cupied mode. To increase the amount of time in Override
mode, press the Override button again. Thirty minutes of over-
ride time will be added for each time the Override button is
pressed up to a maximum of 4 hours. After the 4-hour limit
has been reached, press the Override button again to cancel
Override mode.
Fig. 1 — Thermostat Display
Mo
DISPLAY
SCREEN
MODE
OVERRIDE
INDICATOR
BUTTON
BUTTON
LIGHT
Fig. 2 — Thermostat Front Cover
Form 33CS-11SO
Pg 1
Debonair™
33CS
Commercial
Am
COOL
AUTO
HEAT
DOWN
UP
ARROW
ARROW
BUTTON
BUTTON
2-99
Replaces: New

   Summary of Contents for Carrier DEBONAIR 33CS

  • Page 1

    A Heat or Cool indicator is located on the bottom middle cover of the thermostat. See Fig. 2. The light will be red if the thermostat is in Heating mode. The light will be green if the thermostat is in Cooling mode.

  • Page 2

    Use the UP ARROW and DOWN ARROW buttons to set the maximum number of Occupied periods avail- able. The thermostat can be set to 1, 2, or 3. After the number of Occupied periods has been selected, press the Mode button.

  • Page 3

    Mode and UP ARROW buttons at the same time to exit Programming mode. NOTE: The thermostat will continue to follow the schedule until a new one is entered. • If only one occupied schedule is selected, the Occupied 2 and 3 schedules are skipped.

  • Page 4

    OPERATION The Mode button selects the operating mode of the ther- mostat. If OFF is selected, the thermostat will not enter Heat- ing or Cooling mode. If HEAT is selected, the thermostat will only enter Heating mode (if the room temperature is below the heating set point).

  • Page 8

    Copyright 1999 Carrier Corporation Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Book 1 PC 111 Catalog No. 533-347 Printed in U.S.A. Form 33CS-11SO Pg 8 2-99 Replaces: New...

Comments to this Manuals

Symbols: 0
Latest comments: