Explanation Of Jumper Settings; W3 Jumper Setting; Hum Jumper Setting - Carrier 33CS420-01 Owner's Manual

Explanation of Jumper Settings

Explanation of Jumper Settings

W3 JUMPER SETTING

If the jumper for MISC1, MISC2, or MISC3 is set to W3, the corresponding MISC screw terminal
on the backplate will control a third stage of heat.
W3 MULTI-STAGE OPERATION EXPLAINED - SECTION 13.4
The 3rd Stage of Heat is turned on when:
(A) The 1st and 2nd stages have been on for the time required (steps 23
and 24, page 13.6). It is adjustable from 0-60 minutes and the default
And
is two minutes.
(B) The temperature from the setpoint is equal to or greater than: the set-
point plus the 1st stage deadband (step #20, 13.5), plus the 2nd stage
deadband (step #21, 13.5) plus the 3rd stage deadband (step #22,
13.5). This 3rd stage deadband is adjustable from 0-10 degrees and
the default is two degrees.
Heating
Deadband Deadband
db 3 db 2
(adj. 0-10 ) (adj. 0-10 )
3rd Stage 2nd Stage 1st Stage
turn on turn on turn on
DECREASE

HUM JUMPER SETTING

17
If the jumper for MISC1, MISC2, or MISC3 is set to HUM, the corresponding MISC screw
terminal on the backplate will control a humidification system.
HUMIDIFICATION OPERATION - SECTION 9
If your HVAC unit is equipped with a humidification system and the Humidity
Module (sold separately) has been installed, the thermostat will provide power
to the MISC1, MISC2, or MISC3 terminal of the thermostat when the
humidity in the home falls below the humidity setpoint you have chosen.
The value for this setpoint ranges from 0% to 60%. If no humidity is desired or
if a humidification system has not been installed, set the value to 0%.
Cooling
Deadband Deadband Deadband
db 1 db 1 db 2
(adj. 1-6 ) (adj. 1-6 ) (adj. 0-10 )
Heat Cool 1st Stage
Setpoint Setpoint turn on
TEMPERATURE INCREASE
Page 17.3
Carrier
2nd Stage
turn on