Adjusting The Setpoint Temperature; Selecting System Mode - Carrier TB-24 Installation And Operation Manual

Adjusting the Setpoint temperature

Note: The setpoint must be different than 10, 11ºC/50, 52ºF.
In One setpoint configuration:
1
Press the [+] or [-]buttons once to view the setpoint
temperature.
2
Press again to adjust the setpoint.
In Two setpoints configuration:
1
Press the [+] or [-] buttons once - " " and the setpoint
temperature for cooling will appear on display.
2
Use the [+] or [-] buttons to adjust the setpoint for cooling.
3
Press the [Mode] button or wait 3 seconds. " " and the
setpoint temperature for heating will appear on display.
4
Use the [+] or [-] buttons to adjust the setpoint for heating.
Note: The setpoint for cooling must be higher than the setpoint for
heating.

Selecting system mode

Press the [Mode] button to switch between system modes.
Notes:
•
During demand for cooling or heating, the active mode will
flash.
•
In Auto mode, the active mode icon (Cool or Heat) will flash.
•
Auto mode is not available in 2-Pipe system configuration.
ComfortVu™ BACnet Thermostat Model Standard TB-24 (24 Vac)Carrier Proprietary and Confidential
Installation and Operation Guide
9
CARRIER CORPORATION ©2024
All rights reserved