Programming A Security Level - Carrier 33CS450-01 Owner's Manual

Proooramming a Security Level
When a security level has been programmed, the thermostat will allow
limited adjustment to the setpoints (steps # 8 and 9). In security
levels 2 and 3, the thermostat is forced into the Program On mode.
To disable the security feature, set the value in step #7 to 0; this will
cause steps # 8 and 9 not to appear.
MODE @ Press the MODE button. While holding Note: Press the MODE
the MODE press the PROGRAM button momentarily
PROGRAM @ ' to move through the
button to enter Setup screens, setup screens. Press
MODE @ Press the MODE button repeatedly _ .__t;_wards through the
until this setup screen appears. \ ____ screens.
Select the security level:
0_No _ecurity in effect
l=Setpoint range limited
2=I+ program on all times
3-2 + prohibits setpoint
changes
Step #8 appears only
if step #7 is not 0
//4 (35 % 99_
Adjust the maximum
allowable heat setpeint
when security s in effect
xSf
Step #9 appears only
ff step #7 is not O
Press
MODE @
Press
PROGRAM @
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds
Page 8.4
,-,7i
od
MODE @
Adjust the m n mum }_P _i _1_ _F
when security s n effect
(35°" 99°) o Press