Table of Contents
Advertisement
Using the Progressive Car Finder Feature
Press the
volume, increasing in volume each time the button is pressed.
Using the Personal Protection Alarm (Panic)
Press and hold the
alarm. During panic mode, the normal function of the transmitter buttons will be
suspended. The transmitter's
door (if the option is installed). To stop the alarm, press and hold the
the transmitter again for 3 seconds. The system will automatically stop after 30
seconds.
Programmed Transmitter Notification
As a security precaution each time the vehicle's ignition is turn on the status LED
light with flash the number of transmitters programmed into the system. This helps
to identify unauthorized transmitters from accessing your vehicle. If you believe an
unauthorized transmitter has been programmed to your system, contact your
installing dealer for assistance.
Valet Mode
When valet mode is activated the status LED will light solid, and all security
functions will be disabled. To enter or exit valet mode simply follow the 4 steps
outlined below:
1.
Turn the vehicle's ignition ON.
2.
Push and hold the programming/valet button.
3.
The LED will turn on solid when valet mode is active
4.
Release the programming/valet button.
Eliminating Arm / Disarm Notification Chirps
System ARM/DISARM chirps can be toggled ON or OFF without entering the
programming feature banks.
1.
Turn the ignition ON then OFF.
2.
Press and release the valet/programming button 3 times. The system
will respond with 1 chirp for ON or 2 chirps for OFF.
ca6552/6552sst. 2011 Audiovox Electronics Corporation. All rights reserved.
button to locate your vehicle. The system will sound 5 times at low
button for 3 seconds to activate the personal protection
and
buttons can be used to lock and unlock the
button on
5
Advertisement
Table of Contents
