Audiovox Prestige APS99BT3 Owner's Manual

Audiovox Prestige APS99BT3 Owner's Manual

Audiovox car accessories owner's manual

Advertisement

Available languages

Available languages

The transmitters included with the system have been pre - programmed at the
factory, with each button pre - assigned to control a specific function of the
system. Although the system in the vehicle has either a 3, 4, or 5 channel
RECEIVER, depending on the model, the transmitters included with the system
are 7 channel transmitters. This allows you to program each transmitter to
more than one vehicle in two car families, and also allows you to change which
button or buttons control certain functions of the system. ( Example:
Transmitter channel 5, shown below, can be programmed to activate Receiver
channel 2.) Refer to the chart below for access to each of the transmitter
channels, and for the standard factory button assignments.
TRANSMITTER
CHANNEL BUTTONS CHANNEL
1
2
OPT. 1
3
OPT. 2
4
&
5
&
6
&
7
&
&
* Remote Emergency Panic is available only on certain models.
* Door Lock/Unlock may require additional components in certain vehicles.
** Some of the more common accessories for these additional channels are;
AS 9075 Remote Car Starter
AS 9256 Remote Trunk Release Relay
AS 9154 Remote Garage Door Interface
AS 9153 Remote Window Roll Up
Model : APS99BT3
SYSTEM RECEIVER
FUNCTION
1
Remote Arm & Disarm
*Remote Emergency Panic
*Remote Door Lock & Unlock
3
Push And Hold For 3 Seconds For Opt1
Release, Push 2 Times For Aux. Out.
4
** Pulsed Output for Accessories
5
** Switched Output for Accessories
-
-
-
-
-
-

Advertisement

Table of Contents
loading

Summary of Contents for Audiovox Prestige APS99BT3

  • Page 1 ** Some of the more common accessories for these additional channels are; AS 9075 Remote Car Starter AS 9256 Remote Trunk Release Relay AS 9154 Remote Garage Door Interface AS 9153 Remote Window Roll Up Model : APS99BT3 SYSTEM RECEIVER FUNCTION...
  • Page 2: Programming Transmitters

    PROGRAMMING TRANSMITTERS: It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically exit program mode.
  • Page 3 Up to 4 transmitters can be programmed, press and hold the selected button of each additional transmitter until the chirp tone is heard, or move to step #5 5. Press and release the valet/override switch one time to advance to channel 2.
  • Page 4: Quick Reference

    (b) Press and hold any combination of two buttons simultaneously, until the siren emits a long chirp tone. This confirms that programming of channel 4 was successful. Up to 4 transmitters can be programmed, press and hold the selected button of each additional transmitter until the chirp tone is heard, or press and release the push button switch to exit the programming mode, or turn the ignition switch off to exit the programming mode.
  • Page 5: Battery Replacement

    BATTERY REPLACEMENT: The transmitter incorporates a small red LED built into the case. This LED can be used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. To replace the battery... 1. Remove the transmitter cover by removing the small screw from the back of the transmitter case.
  • Page 6 Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. 9. Mail this form, and your check, to ; Audiovox Corporation 150 Marcus Blvd. Hauppauge, N.Y. 11788 Attn.: TRANSMITTER DEPARTMENT PD-31...
  • Page 7 AS 9075 Télécommande de démarreur du véhicule AS 9256 Télécommande de relais d’ouverture de capot de coffre AS 9154 Télécommande Interface de porte de garage AS 9153 Télécommande de fermeture des vitres TRANSMETTEURS : APS99BT3 Modèle FONCTION...
  • Page 8 PROGRAMMATION DES TRANSMETTEURS Il est important de se rappeler que, pendant la programmation, chaque étape individuelle doit être accomplie dans un délai de 15 secondes suivant l’étape précédente. Lorsqu’on laisse expirer le délai de 15 secondes, le système sort automatiquement du mode de programmation. Pour signaler cette situation, la sirène émet un son long.
  • Page 9 La longue tonalité de gazouillement confirme que la programmation du canal 1 était réussie. Jusqu'à 4 émetteurs peuvent être programmés, actionnent le bouton choisi de chaque émetteur additionnel jusqu'à ce que la longue tonalité de gazouillement soit entendue, ou actionner et libérer le commutateur à...
  • Page 10 Jusqu'à 4 émetteurs peuvent être programmés, actionnent le bouton choisi de chaque émetteur additionnel jusqu'à ce que la longue tonalité de gazouillement soit entendue. (b) Actionnez le bouton d'Opt sur votre émetteur de keychain jusqu'à ce que la sirène émette une longue tonalité de gazouillement. Ceci confirme que la programmation du canal 3 était réussie..Jusqu'à...
  • Page 11: Remplacement De Batterie

    QUICK REFERENCE: Vous pouvez programmer n'importe quel canal individuel, sans reprogrammer tous les canaux, par apres le diagramme rapide de reference ci-dessous. (Non Toutes les Unites Ont 4 Canaux) Canal de Commutateur de valet récepteur actionnez le commutateur de valet 3 fois 1 CLIGNOTEMENT actionnez le commutateur de valet 4 fois 2 CLIGNOTEMENT actionnez le commutateur de valet 5 fois 3 CLIGNOTEMENT actionnez le commutateur de valet 6 fois 4 CLIGNOTEMENT...
  • Page 12 Mastercard Visa Chèque ou mandat postal * Libeller les chèques à l’ordre de Audiovox Corporation 7. Numéro de carte de crédit : __________________________________ 8. Date d’expiration de la carte de crédit :_________________________ Les clients payant par carte de crédit peuvent placer leur commande de transmetteurs par téléphone en appelant le 1-800-645-4995 et en suivant les instructions de...

This manual is also suitable for:

1285749b

Table of Contents