Brother Innov-is NX-650 Operation Manual page 89

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
g Gently hold the end of the upper thread in
your left hand, and then start sewing.
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
h Cut the threads, raise the presser foot lever,
and then remove the fabric.
i Raise the buttonhole lever to its original
position.
j Insert a pin along the inside of one bar tack at
the end of the buttonhole stitching to prevent
the stitching from being cut.
a Pin
Use the seam ripper to cut towards the pin and
k
open the buttonhole.
a Seam ripper
For keyhole buttonholes, use the eyelet punch
to make a hole in the rounded end of the
buttonhole, and then use the seam ripper to cut
open the buttonhole.
1
1
a Eyelet punch
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
CAUTION
● When opening the buttonhole with the
seam ripper, do not place your hands in
the cutting direction, otherwise injuries
may result if the seam ripper slips.
■ Changing the density of the stitching
Adjust the stitch length.
–
• For details, refer to "Adjusting the stitch
length" (page 60).
• If the fabric does not feed (for example, if it is
too thick), decrease the density of the
stitching.
Buttonhole Stitching/Button Sewing 87
1
+
3