Brother Innov-is NX-650 Operation Manual page 154

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Symptom
The upper thread was not threaded
correctly (for example, the spool is
not installed correctly, the spool cap
is too big for the spool being used, or
the thread has come out of the
needle bar thread guide).
There are knots or tangles in the
thread.
The selected needle is not
appropriate for the thread being
used.
The upper thread tension is too tight. Loosen the upper thread tension.
The thread is tangled, for example, in
the bobbin case.
The upper thread
breaks. The needle is bent or blunt.
The needle is incorrectly installed.
The area around the hole in the
needle plate is scratched, or has a
burr on it.
The area around the hole in the
presser foot is scratched, or has a
burr on it.
The bobbin case is scratched, or has
a burr on it.
A bobbin designed specifically for
this machine is not used.
The bobbin thread is incorrectly
installed.
The bobbin is scratched or does not
rotate smoothly, or has a burr on it.
The lower thread is
The thread is tangled.
tangled or breaks.
A bobbin designed specifically for
this machine is not used.
152
Probable Cause Remedy
Correct the upper threading.
Remove any knots or tangles.
Select a needle that is appropriate
for the type of thread being used.
Remove the tangle thread. If the
thread is tangled in the bobbin
case, clean the race.
Replace the needle.
Correctly install the needle.
Replace the needle plate. Contact
your dealer or the nearest
authorized service center.
Replace the presser foot. Contact
your dealer or the nearest
authorized service center.
Replace the bobbin case. Contact
your dealer or the nearest
authorized service center.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
Correctly install the bobbin
thread.
Replace the bobbin.
Remove the tangled thread and
clean the race.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
Reference
page 28
–
page 38
page 57
page 149
page 39
–
–
–
page 22
page 26
–
page 149
page 22