Troubleshooting - Brother Innov-is NX-650 Operation Manual

Computerized sewing machine
Hide thumbs Also See for Innov-is NX-650:
Table of Contents

Advertisement

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Troubleshooting

If the machine stops operating correctly, check the following possible problems before requesting service.
If the problem persists, contact your dealer or the nearest authorized service center.
Symptom
The sewing
machine does not
operate.
The needle breaks.
Probable Cause
The machine is not turned on.
The "Start/Stop" button was not
pressed.
The presser foot lever is raised.
The "Start/Stop" button was pressed,
even though the foot controller is
connected.
The needle is incorrectly installed.
The needle clamp screw is loose.
The needle is bent or blunt.
The combination of fabric, thread
and needle is not correct.
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
The upper thread tension is too tight. Loosen the upper thread tension.
The fabric is pulled too much.
The spool is incorrectly installed.
The area around the hole in the
needle plate is scratched, or has a
burr on it.
The area around the hole in the
presser foot is scratched, or has a
burr on it.
The bobbin case is scratched, or has
a burr on it.
A bobbin designed specifically for
this machine is not used.
Remedy
Turn on the machine.
Press the "Start/Stop" button.
Lower the presser foot lever.
Do not use the "Start/Stop" button
when the foot controller is
connected. To use the "Start/
Stop" button, disconnect the foot
controller.
Correctly install the needle.
Use the screwdriver to firmly
tighten the screw.
Replace the needle.
Select a thread and needle that
are appropriate for the type of
fabric being sewn.
Attach the presser foot that is
appropriate for the type of stitch
that you wish to sew.
Lightly guide the fabric.
Correctly install the spool.
Replace the needle plate. Contact
your dealer or the nearest
authorized service center.
Replace the presser foot. Contact
your dealer or the nearest
authorized service center.
Replace the bobbin case. Contact
your dealer or the nearest
authorized service center.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.

Troubleshooting 151

Reference
page 17
page 52
page 52
page 39
4
page 38
page 138
page 57
page 28
page 22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nx-650qNx-800

Table of Contents