Cisco CRS-1 - Carrier Routing System Router Troubleshooting Manual page 150

Verifying and Troubleshooting Pluggable Optical Interfaces
DETAILED STEPS
Command or Action
Step 1
show hw-module subslot address brief
pluggable-optics
Example:
RP/0/RP0/CPU0:router# show hw-module subslot
0/6/4 brief pluggable-optics
Step 2
show hw-module subslot address status
pluggable-optics
Example:
RP/0/RP0/CPU0:router# show hw-module subslot
0/6/4 status pluggable-optics
Step 3
show hw-module subslot address errors
pluggable-optics
Example:
RP/0/RP0/CPU0:router# show hw-module subslot
0/6/4 errors pluggable-optics
Step 4
show hw-module subslot address registers
pluggable-optics
Example:
RP/0/RP0/CPU0:router# show hw-module subslot
0/6/4 registers pluggable-optics
Step 5 Contact Cisco Technical Support.
The following example shows typical outputs for these commands on systems.
RP/0/RP0/CPU0:router#show hw-module subslot 0/6/4 brief pluggable-optics
SPA 0/6/4 device pluggable-optics 0/0 info:
SPA 0/6/4 device pluggable-optics 1/0 info:
SPA 0/6/4 device pluggable-optics 2/0 info:
SPA 0/6/4 device pluggable-optics 3/0 info:
SPA 0/6/4 device pluggable-optics 4/0 info:
int sonet 6/4/4:
SPA 0/6/4 device pluggable-optics 5/0 info:
int sonet 6/4/5:
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
5-140
ID: SFP
Extended ID: 4
Xcvr Type: OC12 SR-1/STM4 MM (8)
Connector: LC
Vendor name: CISCO-OCP
Vendor part number: TRPD12MM2EAS-CS
State: Enabled
ID: SFP
Extended ID: 4
Purpose
Displays a brief summary of the pluggable optics status for
all nodes, including optics type, vendor, and state. Check
that the state is enabled for the node that you are
troubleshooting.
Displays the status of the pluggable optics for the specified
node, including faults and environmental data. Check that
the state and the transceiver are enabled. Check for any
warnings or alarms.
Displays any errors that are present on the node. Note if
there are any errors.
Verify that Phased Initialization displays Phase Reached: 4.
Verify that Socket Verification displays "passed" for both
Compatibility and Security.
Displays all available information on the optics including
the IDPROM contents.
For Cisco Technical Support contact information, see the
"Obtaining Documentation and Submitting a Service
Request" section on page viii
Chapter 5 Troubleshooting Interfaces
in the Preface.
OL-21483-02