I/O Device Configuration - Asus A7V266-MX User Manual

2.5.2 I/O Device Configuration

Swap Floppy Drive
Onboard FDC Controller
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
ECP Mode USE DMA
EPP Mode Select
VIA-3058 AC97 Audio
VIA-3043 OnChip LAN
Onboard LAN Boot ROM
Game Port Address
MIDI Port Address
MIDI Port IRQ
Swap Floppy Drive [Disabled]
Enable this option to assign physical drive B to logical drive A, and vice-versa.
Configuration options: [Disabled] [Enabled]
Onboard FDC Controller [Enabled]
This field allow you to enable the onboard FDC controller.
Configuration options: [Enabled] [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
These fields allow you to set the address for the onboard serial connector.
Configuration options: [3F8/IRQ4] [2F8/1RQ3] [3E8/IRQ4] [2E8/IRQ3] [Auto]
[Disabled]
Onboard Parallel Port [378/IRQ7]
This field allows you to set the address of the onboard parallel port connector.
Configuration options: [378/IRQ7] [278/IRQ5] [3BC/1RQ7]
Parallel Port Mode [ECP+EPP]
This field allows you to set the operation mode of the parallel port. [SPP] allows
normal-speed operation but in one direction only; [EPP] allows bidirectional parallel
port operation; [ECP] allows the parallel port to operate in bidirectional DMA mode;
[ECP+EPP] allows normal speed operation in a two-way mode.
Configuration options: [ECP+EPP] [EPP] [ECP] [SPP]
ECP Mode USE DMA [3]
This field sets the parallel port DMA channel for the selected ECP mode. The
default setting is 3. This selection is available only if you select [ECP] or
[ECP+EPP] in the Parallel Port Mode item. Configuration options: [3] [1]
2-18
I/O Device Configuration
[Disabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[ECP+EPP]
[3]
[EPP1.7]
[Auto]
[Auto]
[Disabled]
[201]
[330]
[10]
If the system has two
floppy drives, choose
[Enable] to assign
physical drive B to
logical drive A and
vice-versa.
Chapter 2: BIOS Information