Advanced - Bosch VIP XD Installation And Operating Manual

VIP XD
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
5.19

Advanced

The settings on this page are used to implement advanced settings for the network.
Some changes only take effect after the unit is rebooted. In this case, the Set button changes
to Set and Reboot.
1.
2.
SNMP
The VIP XD supports the SNMP V2 (Simple Network Management Protocol) for managing and
monitoring network components, and can send SNMP messages (traps) to IP addresses. The
unit supports SNMP MIB II in the unified code. If you wish to send SNMP traps, enter the IP
addresses of one or two required target units here.
If you select On for the SNMP parameter and do not enter an SNMP host address, the VIP XD
does not send them automatically, but only replies to SNMP requests. If you enter one or two
SNMP host addresses, SNMP traps are sent automatically. Select Off to deactivate the SNMP
function.
1. SNMP host address / 2. SNMP host address
If you wish to send SNMP traps automatically, enter the IP addresses of one or two required
target units here.
Bosch Security Systems
Make the desired changes.
Click the Set and Reboot button. The VIP XD is rebooted and the changed settings are
activated.
Installation and Operating Manual
Configuration Using a Web Browser | en
DOC | V4.0 | 2009.06
47