Error Displays - Panasonic AG-AC160A Operating Instructions Manual

„
N
[NO CARD]
No memory card is inserted.
„
R
[REPAIR CLIP?]
Do you wish to repair clips now?
„
S
[SET DATE AND TIME]
Set the date and time.
„
T
[THE CLIP IS PROTECTED. PLEASE CANCEL
PROTECTION.]
The clip is protected. Please release the protection.
[THE RECORDING IS STOPPED (OVER THE
LIMITATION)]
Recording will stop. (Continuous recording for 12
hours)
[THE TC MODE IS CHANGED TO "NDF"]
NDF is selected as the TC mode setting.
[THIS BATTERY CANNOT BE USED.]
This battery cannot be used.
[THIS CARD CANNOT RECORD IN VIDEO
MODE.]
This memory card cannot be used for video
recording.
[THUMBNAIL DATA ERROR IS DETECTED.]
An error has been detected in the thumbnail
information.
„
U
[UNABLE TO FORMAT.]
The memory card cannot be formatted.
„
W
[WRITE PROTECT]
This memory card is write-protected.

Error displays

The following messages are displayed when an
error has occurred in the camera or the memory
card. If the problem is not solved by switching the
power off and back on again, either change the
memory card in accordance with the instructions
displayed, or consult your dealer.
„
E
[ERROR OCCURRED. PLEASE TURN POWER
OFF.]
Displayed when an error has occurred on the
camera. Turn off the power.
„
R
[REC WARNING]
Displayed when an error has occurred during
recording. Start the recording again. If the warning
appears again, consult your dealer.
• Switch the power off if the warning continues
to appear.
• Try inserting a different memory card if
the warning appears again after restarting
recording.
„
S
[SYSTEM ERROR TURN POWER OFF]
Displayed when an error has occurred in the
system. Switch off the power and back on again.
• If this error is displayed when accessing the
memory card, such as when deleting a clip,
the memory card may be damaged. Please
replace it with a new memory card.
• If this error is displayed during repair, please
use the AVCCAM Restorer contents repair
software. (Page 16)
81