Table of Contents
Advertisement
EasyBUILD 7.1 build 600 (or later).
Software
MegaRAID Storage
Manager
Configuring LSI MegaRAID SAS 8204ELP
Please refer to the Appendix C. for the LSI MegaRAID SAS 8204ELP
configuration.
Installation Tips
Since Red Hat Enterprise Linux 4.0 Update4 cannot recognize the
1.
MegaRAID SAS 8204ELP, you need to make a driver diskette from the
EasyBUILD 7.1 build 600 (or later) first before the installation.
Type linux dd when the prompt boot: appears at the start.
2.
Please select the fd0 as the Driver Disk Source.
3.
Follow the instruction to load the driver for MegaRAID SAS 8204ELP from
4.
the driver diskette.
If you have installed the ATI FireGL V5200 in the system, you need to
5.
install additional package at the Package Installation Defaults. If you use
the onboard XGI Z9s, please follow the instructions to finish the
installation directly.
At the Package Installation Defaults, select Customize software packages
6.
to be installed.
At the Package Group Selection step, select Development Tools and under
7.
Development.
After selecting the additional package, follow the normal procedure to
8.
finish the installation.
Gigabit Ethernet Driver Installation
The Gigabit Ethernet driver installation is the same as LSI MegaRAID SAS
8708ELP installed. Please refer to the Red Hat Enterprise Linux 4.0 Update 4
Installation (with LSI MegaRAID SAS 8708ELP) Gigabit Ethernet Driver
Installation section.
VGA Driver Installation (onboard XGI Z9s)
The XGI Z9s driver installation is the same as LSI MegaRAID SAS 8708ELP
installed. Please refer to the Red Hat Enterprise Linux 4.0 Update 4 Installation
(with LSI MegaRAID SAS 8708ELP) XGI Z9s Driver Installation section.
VGA Driver Installation (ATI FireGL V5200)
The ATI FireGL V5200 driver installation is the same as LSI MegaRAID SAS
8708ELP installed. Please refer to the Red Hat Enterprise Linux 4.0 Update 4
75
Version
Directory on EasyBUILD
2.07-00
\app\g5450\sas\8204ELP\Linux\
Altos G5450 Installation Configuration Guide
Advertisement
Table of Contents
