Table of Contents
Advertisement
Altos G5450 Installation Configuration Guide
Drivers Required
For Red Hat Enterprise Linux 4.0 EM64T Update 4 Installation, the following
device drivers are required.
Device
Onboard SATA
RAID
Onboard NVIDIA
NFP3600 Chipset
Onboard NVIDIA
nForce Networking
Controller
Onboard XGI Z9s
ATI FireGL V5200
Software Required
The management utility for onboard SATA RAID can be found in the EasyBUILD
7.1 build 600 (or later).
Software
Onboard SATA
RAID utility
Configuring onboard SATA RAID
Please refer to the Appendix A. for the onboard SATA RAID configuration.
Installation Tips
Since Red Hat Enterprise Linux 4.0 EM64T Update4 cannot recognize the
1.
onboard SATA RAID, you need to make a driver diskette before the
installation. The driver disk is not available in EasyBUILD 7.1 build 600 yet.
The driver will be available in GCSD website and next release of
EasyBUILD.
Type linux dd when the prompt boot: appears at the start.
2.
Please select the fd0 as the Driver Disk Source.
3.
Follow the instruction to load the driver for onboard SATA RAID from the
4.
driver diskette.
At the Package Installation Defaults, select Customize software packages
5.
to be installed.
At the Package Group Selection step, select Graphic Internet under
6.
Applications.
If you have installed the ATI FireGL V5200 in the system, please also select
7.
Development Tools and under Development. If you don't have ATI FireGL
V5200, please go to next step directly
70
Version
Directory on EasyBUILD
N/A
N/A
N/A
OS built-in
0.60
\Disk\g5450\nic\Nvidia\x64\rhel4ud4\
1.2.53
\Disk\g5450\onboard\xgiz9s\x64\rhel4u
d4
8.35.5
N/A
Version
Directory on EasyBUILD
N/A
N/A
Advertisement
Table of Contents
