Drive Motor; Interlock Switch - Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual

Disconnect power before accessing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

DRIVE MOTOR

Refer to page 4-23 for the procedure for ac-
cessing the drive motor.
1. Unplug washer or disconnect power.
2. Disconnect the 5-wire connector from the
drive motor.
3. Set the ohmmeter to the R X 1 scale.
4. Touch the ohmmeter test leads to the
following motor pins. For each measure-
ment, the meter should indicate approxi-
mately 6 Ω:
Pins 1 and 2
Pins 2 and 3
Pins 1 and 3
Electrical Shock Hazard
Pin 1
Drive Motor
Connector
5-8

INTERLOCK SWITCH

Refer to page 4-25 for the procedure for ac-
cessing an interlock switch.
1. Unplug washer or disconnect power.
2. Disconnect the wire connectors from ei-
ther of the interlock switch terminals.
3. Set the ohmmeter to the R X 1 scale.
4. Touch the ohmmeter test leads to the
two interlock switch terminals. The meter
should indicate an open circuit with the
actuator button pushed in, and a closed
circuit (0 Ω) with the actuator button out.
COM
N.C.
Actuator Button