Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual page 53

c) Pull the door switch assembly out and
turn it over so that you can access the
connectors.
d) Unlock the tabs and disconnect the
three wire connectors from the door
switch terminals, then remove the as-
sembly.
8. To remove the bellows:
a) Remove the two T-20 Torx screws
from the door switch assembly (see
the photo in step 7b).
b) Remove the front panel from the
washer (see steps 15 and 16 on page
4-11 for the procedure).
c) Turn the bellows retaining clamp screw
counterclockwise until the clamp is
loose enough to remove it from around
the bellows (see the top right photo).
NOTE: It may be necessary to com-
pletely remove the screw from one
end of the clamp.
3 Door Switch
Assembly Connectors
4-15
Bellows Retaining
Clamp Screw
d) Remove the bellows retaining clamp
from around the bellows.
Remove Bellows
Retaining Clamp
Continued on the next page.