Whirlpool Washing Machine User Manual
  1. Manuals
  2. Brands
  3. Whirlpool Manuals
  4. Washer
  5. FULL ELECTRONIC WASHING MACHINE
  6. User manual
Whirlpool Washing Machine User Manual

Whirlpool Washing Machine User Manual

Front-loading washing machine
Hide thumbs Also See for Washing Machine:

Advertisement

Table of Contents

See also: Programme Chart , User Manual
CONTENTS

Advertisement

Table of Contents
loading

Related Manuals for Whirlpool Washing Machine

Summary of Contents for Whirlpool Washing Machine

  • Page 1: Table Of Contents

    CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE DOOR CHILD SAFETY (IF AVAILABLE) BEFORE THE FIRST WASH CYCLE PREPARING THE WASH DETERGENTS AND ADDITIVES REMOVING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE...

  • Page 2: Before Using The Washing Machine

    • Move the appliance without lifting it by the • Do not operate the washing machine if it has worktop been damaged during transport. Inform the • Install the appliance on a solid and level floor...

  • Page 3: Precautions And General Recommendations

    2.Disposing of packaging and old washing the machine or disconnect it from the mains machines • Clean the outside of the washing machine with a • The washing machine is built from reusable damp cloth. Do not use abrasive detergents materials.

  • Page 4: Description Of The Washing Machine

    DESCRIPTION OF THE WASHING MACHINE 1. Worktop 2. Control panel 3. Detergent dispenser 4. After-Service sticker (inside door) 5. Door 6. Child safety (inside door, if available) 7. Filter (inside compartment door) 8. Plinth 9. Adjustable feet DOOR To open the single glass door hold the door handle, press the inside handle and pull the door up.

  • Page 5: Child Safety (If Available)

    • Follow the manufacturer’s instructions • Delicates • Plastic and rubber parts of the washing machine Wash small items (e.g. nylon stockings, belts can be stained by dyes etc.) and items with hooks (e.g. bras) in a Loading the laundry washbag or pillow case with a zip fastener.

  • Page 6: Detergents And Additives

    Descaler could The cleaning effect deteriorates. contain components which can attack parts of your If the washing machine detects too much foam, it washing machine. may prevent spinning. Do not use any solvents (e.g. turpentine, benzine).
  • Page 7 • When using descaling agents, bleaches or dyes, make sure that they are suitable for washing machines. Descalers could contain components that can attack parts of your washing machine. • Do not use any solvents in the washing machine (e. g. turpentine, benzine). • If you use starch powder, proceed as follows: 1.

  • Page 8: Removing The Filter

    REMOVING THE FILTER We recommend that you check and clean the filter regularly, at least two or three times a year. Especially: • When the appliance does not drain or spin properly • If the pump is blocked by a foreign body (e.g. buttons, coins or safety pins) IMPORTANT: make sure the water has had time to cool before draining the appliance.

  • Page 9: Draining Residual Water

    5. Insert the filter with the guide pin upwards and screw it in clockwise to the stop (handle horizontal). 6. Fold the cover up and lock it. Before using the washing machine again: 1. Pour approx. 1 litre of water into the detergent drawer to reactivate the Eco system.
  • Page 10 2. Clean the internal mesh filter and screw the water inlet hose back onto the tap. 3. Now unscrew the inlet hose on the rear of the washing machine. 4. Pull off the mesh filter from the washing machine connection with universal pliers and clean it.

  • Page 11: Troubleshooting Guide

    TROUBLESHOOTING GUIDE Depending on the model, your washing machine is • “Start/Pause” lamp is flashing. Press “Start/ equipped with various automatic safety functions. Pause” button; This enables faults to be detected in good time and • the “Rinse Hold” button is pushed, terminate the safety system can react appropriately.
  • Page 12 a. Water inlet fault (no or insufficient water supply) c. Electrical module fault For models with a fault display, the “Water tap” For models with a fault display “F4” to “F15” are indicator is on or the display alternately shows displayed and some or all Spin Speed Selection “FH”.

  • Page 13: After-Sales Service

    2.Restart the programme to check whether the • The service code (number after the word problem has solved itself. SERVICE). 3.If the washing machine continues to function incorrectly, call After-Sales Service. The After-Sales Service sticker is on the inside of the door.

  • Page 14: Electrical Connection

    If the fitted plug is not suitable for your socket outlet, Please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations.

This manual is also suitable for:

Awm 6100

Table of Contents