2.
From above the validation section, insert a validation paper straight
into the slot, keeping the right side of the paper at the marked point
shown in the following note.
Note:
Keep the edge of the validation paper in the position shown on the label in the
picture below.
When the validation paper is ejected and the VALIDATION/FEEDER
3.
LED starts flashing, pull the paper straight out of the printer.
Troubleshooting
ERROR LED is flashing or lit
❏
The printer stops printing when the print head temperature goes up
or down to an abnormal value. Printing restarts automatically when
the print head temperature returns to normal.
❏
Make sure that the printer covers are properly closed.
❏
If a paper jam has occurred, remove the jammed paper, referring to
the next section "Paper Jams."
❏
Turn off the printer, and then turn it on after a while. If the error
persists, consult a qualified service person for repair.
❏
When no ink cartridge is installed, the ERROR LED comes on. Install
an ink cartridge.
❏
When the roll paper is enabled but no paper roll is installed, the
ERROR LED comes on. Install a paper roll.
Paper Jams
Follow these steps to remove the jammed paper or card.
English
Label indicating the
insertion position
TM-J9000/J9100 19