English
Note:
If the scanner unit is not pushed in properly, a cover open error occurs, and the
ERROR LED comes on.
5.
To attach the scanner cover, push it down into the connecting part
firmly until it clicks in place.
Validation Printing
Notes on Validation Printing
❏
Do not use paper smaller than 152 × 68 mm {5.98 × 2.68 in} (W × H).
❏
Do not use paper larger than 230 × 100 mm {9.06 × 3.94 in} (W × H).
❏
Do not use carbon paper or other multi-ply paper.
❏
Make sure that the paper has no curl, bending (especially on the
corners), warpage, or wrinkles.
❏
Do not use paper with paper clips, staples, adhesive tape, or other
foreign materials attached.
❏
Do not open any covers while the operation is in progress.
Follow the steps below to run validation printing.
1.
Wait until the VALIDATION/FEEDER LED starts flashing.
18 TM-J9000/J9100