Alpine PXA-H800 Owner’s Manual page 26

From a PC
5
Click a frequency and drag up or down to adjust the
level.
Frequency:
Front/Rear/Center: 20Hz~20kHz (1/3 octave step)
SubW:
Level: -12 to +12dB (in 0.5dB step)*
* When ImprintEQ is enabled, -6 to +6 dB (in 0.5 dB steps)
• Mouse trace function
When you click [Mouse Trace OFF], the mouse trace function
becomes enabled, and [Mouse Trace OFF] changes to [Mouse Trace
ON]. When dragged, the curve (settings) changes in accordance with
the movement of the cursor.
To disable the mouse trace function, click the [Mouse Trace ON].
• You can also make adjustments by operating the settings indication
area (Frequency, Level).
The current setup value will be displayed at the bottom of the Screen.
Click [ ] and select and click a setup value. You can also use the
[Tab], [ ], [ ], [ ], and [
setup value.
6
To adjust another channel, repeat Steps 4 through 5.
• You can listen with Defeat OFF (adjusted setup values) or with
Defeat ON (Initial value) to compare, by clicking either [ON] or
[OFF] of "Defeat" in the main menu while in the adjustment mode.
• By clicking either [ ] or [
mode, you can mute the selected channel.
7
When setting is complete, click [Close Window].
• To enable this function, Defeat should be is set to ON.
• To restore the channel which is currently being adjusted to the
default, click [Ch. Flat]. To restore all the channels to the initial
settings, click [All Reset]. Click [OK] when each confirmation
message appears.
• When the speaker is set to the "OFF" mode, the graphic equalizer
for that speaker cannot be set. Refer to "Setting the Speaker System
(Output System Select)" (page 13)/ "Setting the Speakers (Speaker
Setup)/Setting the Subwoofers" (page 14).
• Check the playable frequency ranges of the connected speakers
before making equalizer adjustments. If the speaker's playable
frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz
or 20 Hz band has no effect. Additionally, you may overload and
damage the speakers.
24
-EN
(1 to 31 Band)
20Hz to 160Hz (1/3 octave step)
(1 to 10 Band)
] keys on your PC to select the
] of "Mute" while in the adjustment
• After the setting, it is recommended to store the setting contents on
the unit. For details, refer to "Storing the Preset Values (Preset
Store)" (page 12).
Displaying the data
1
Click [Show All Data].
The setup values for all the channels will be displayed.