Powershot S400 Digital Elph/Digital Ixus 400 - Canon PowerShot SD100 Software Starter Manual

PowerShot S400 DIGITAL ELPH/DIGITAL
IXUS 400
How to Connect the Camera to a Computer and Prepare to Transfer Data
1
Attach the supplied USB cable to the computer's USB port and the
camera's Digital terminal as shown below.
2
Set the mode switch to the replay mode and turn the camera's
power on. This will prepare the camera to exchange data with the
computer.
CD-ROMs in the Package
•Canon Digital Camera Solution Disk
•ArcSoft Camera Suite 1.2
See ArcSoft Camera Suite 1.2 CD-ROM (p. 106) for information about the
features and installation procedures for the programs on the disk.
Non-Supported Programs and Features
•RAW images cannot be recorded.
•USB Mounter (Macintosh) is not supported.
USB Port
To the Digital
Terminal
USB Cable
1. Slip a fingernail under the
terminal cover and lift to open.
2. Insert it all the way until it clicks.
95