Solution Cooling - AEG OKO-LAVAMAT 82730 Instructions For Use Manual

Instructions for use
Cancel Additional Rinse:
0 1. Turn the program selector to SHORT SPIN (KORT CENTRIFUG., ESSOR.
DELICAT).
2. Keep the button SOAKING (INWEKEN, TREMPAGE) pressed for at least
5 seconds.
As soon as the button is pressed, RINSE
flashes on the program sequence display. After 5 seconds, RINSE
(SPOELEN
further 5 seconds.
3. While RINSE
button SOAKING (INWEKEN, TREMPAGE).
After RINSE
ditional rinse is cancelled.
An additional rinse increases water consumption and the program run
3
time.

Solution Cooling

It may be necessary to cool down the washing solution before pumping
off in order to avoid thermal damage to plastic drainage pipes.
The washing solution is cooled down at the end of the main washing
3
cycle before pumping off (by incoming cold water).
(This setting is only effective for COTTONS/LINEN (WITTE/BONTE WAS,
BLANC/COULEURS) at temperatures of over 40 °C.)
No solution cooling is set when the unit is delivered.
Set the Solution Cooling:
0 1. Turn the program selector to SHORT SPIN (KORT CENTRIFUG., ESSOR.
DELICAT).
2. Keep the button PRE WASH (VOORWAS, PRELAV.) pressed for at least
5 seconds.
After the button has been pressed for 5 seconds, MAIN WASH (HOOFD-
WAS, LAVAGE) flashes on the program sequence display for 5 seconds.
3. While MAIN WASH (HOOFDWAS, LAVAGE) is flashing, release the but-
ton PRE WASH (VOORWAS, PRELAV.).
After the flashing has stopped, the solution cooling is set. It is set until
it is cancelled again.
40
+ +
, RINCAGE ) stops flashing and lights up constantly for a
+ +
(SPOELEN , RINCAGE
+ +
(SPOELEN , RINCAGE
+ +
(SPOELEN , RINCAGE
+
) lights up constantly, release the
+
) has stopped lighting up, the ad-
+
)
+