Additional Rinse And Solution Cooling - AEG OKO-LAVAMAT 82730 Instructions For Use Manual

4. If you want to check whether the solution cooling is set:
– Turn the program selector to SHORT SPIN (KORT CENTRIFUG., ESSOR.
DELICAT).
– Briefly press the button PRE WASH (VOORWAS, PRELAV.).
If MAIN WASH (HOOFDWAS, LAVAGE) flashes on the program sequence
display, the solution cooling is set.
Cancel the Solution Cooling:
0 1. Turn the program selector to SHORT SPIN (KORT CENTRIFUG., ESSOR.
DELICAT).
2. Keep the button PRE WASH (VOORWAS, PRELAV.) pressed for at least
5 seconds.
As soon as the button is pressed, MAIN WASH (HOOFDWAS, LAVAGE)
flashes on the program sequence display. After 5 seconds, MAIN WASH
(HOOFDWAS, LAVAGE) stops flashing and lights up constantly for
5 seconds.
3. While MAIN WASH (HOOFDWAS, LAVAGE) lights up constantly, release
the button PRE WASH (VOORWAS, PRELAV.). After MAIN WASH
(HOOFDWAS, LAVAGE) has stopped lighting up, the solution cooling is
cancelled.
The solution cooling increases water consumption and the program run
3
time.

Additional Rinse and Solution Cooling

You can combine the additional rinse and the solution cooling. Setting
as under "Additional Rinse" and "Solution Cooling".
Instructions for use
41