Water Cooling; Additional Rinse And Water Cooling - AEG OKO-LAVAMAT 88830 User Information

Operating Instructions

Water Cooling

It may be necessary to cool down the washing solution before pumping
it out in order to prevent thermal damage to plastic drainage pipes.
The washing solution is cooled down before pumping out at the end of
3
the washing cycle (by the addition of cold water).
(This setting is only effective with t/COTTONS/LINEN with a tempera-
ture of over 40 °C.)
As supplied from the factory, the water cooling function is not enabled.
Enabling the water cooling function:
0 1. Turn program selector to F (SHORT SPIN).
2. Keep the button k (PRE-WASH) pressed for at least 5 seconds.
After the button has been pressed for 5 seconds,
flashes on the program sequence display for 5 seconds.
l
3. While
After the flashing has stopped, the solution cooling is set. It is active
until it is cancelled again.
4. If you wish to check whether the water cooling function is enabled:
– Turn program selector to F (SHORT SPIN).
– Briefly press the button k (PRE-WASH).
l
If (MAIN WASH) flashes on the program sequence display, the solu-
tion cooling is set.
Disabling the water cooling function:
1. Turn program selector to F (SHORT SPIN).
0
2. Keep the button k (PRE-WASH) pressed for at least 5 seconds.
As soon as the button is pressed,
gram sequence display. After 5 seconds,
hing and lights up constantly for 5 seconds.
l
3. While
(PRE-WASH). After
tion cooling is cancelled.
Solution cooling increases water consumption and the program dura-
3
tion.

Additional Rinse and Water Cooling

The additional rinse cycle and the solution cooling can be combined.
Setting as under "Additional rinse" and "Solution cooling".
42
(MAIN WASH) is flashing, release the button k (PRE WASH).
(MAIN WASH) lights up constantly release the button k
l
(MAIN WASH) has stopped lighting up, the solu-
l
l
(MAIN WASH) flashes on the pro-
l
(MAIN WASH) stops flas-
(MAIN WASH)