ACR Electronics NAUTICAST inland AIS Installation Manual page 48

Select Submenu 7 "Inland AIS Configuration" with cursor button [Up] & [Down] by pressing
Nr. 7 on the keyboard.
N48^12' E 16^26' |1> N/A|2> N/A|3> N/Anm
|----------------------------------
| 5. Transponder Configuration
-----| |
| +- 1. Change User Password
View | +- 2. Region Settings
| +- 3. Alarm Settings
-----| +- 4. Interrogation Settings
| +- 5. Sensor Settings
Msg. | +- 6. GPS Settings
| +- 7. Inland AIS Configuration
-----|
|
Displ|
----------------------------------------
NUM|Select->|
This screen allows the user to toggle the quality of the speed, course or heading information received
from an external device. These settings are normally set to low.
Note: It is highly recommended to keep the settings to low.
Blue Sign:
Toggle the value from <not available> to <used> when a Blue Sign switch is connected. Setting the
blue sign can be done by an external hardware switch. Please see the chapter 3.12 how to connect
the blue sign - cable 2635 (NAU-B502) which includes and RS232 connector as well. Unless you
configure the Blue Sign appropriate, you may not be able to use it.
BlueSign
N48°12' E 16°26' |1> N/A|2> N/A|3> N/Anm
******* Inland AIS Configuration *******
Quality information
Speed
Course : Low
Heading: Low
BlueSign
----------------------------------------
|
44
|
Blue Sign <not available> no blue sign switch is connected
<used> when a blue sign switch is connected
: Low
:<used>
Save | |
|<-Back
| Exit
Y1-03-0212H