ACR Electronics NAUTICAST inland AIS Installation Manual page 74

Input voltage range
Output voltage
Intermittent output power
Transient voltage protection
Electrostatic voltage protection
Output noise
Off load current (quiescent current)
Power conversion efficiency
Isolation
Operating temperature
Storage temperature
Operating humidity
Casework
Connections
Output indicator
Mounting method
Safe area protection: Over current
Over heat
Transients
Catastrophic failure
Approvals
Markings
Switch
Power
240W (10 A)
Isolated
70
24Vdc ± 30%
27.2Vdc +15% -20% at extremes of temperature, load, input
tolerance, etc.
Continuous rating +25%, taken for a maximum of 2 minutes
followed by 8 minutes rest.
Meets ISO7637-2 International standard for 24Vdc commercial
vehicles
Meets ISO10605, ISO14892, >8kV contact, 15kV discharge
<50mV pk-pk (100mV on 24V units) at continuous load. Meets
CISPR25 and VDE0879-3
<100mA
Typically: 90% for non-isolated units, 85% for isolated units
>400Vrms between input, output and case, on isolated
products only.
-25°C to +30°C to meet this specification table -30°C to +80°C de
rate linearly to 0A
-25°C to +100°C
95% max., non-condensing
Anodised aluminum, glass filled polycarbonate, dust water and
impact resistance to IP533 (excludes Ddi 24-24 240 which is
ventilated and fitted with a cooling fan
Four 6.3mm push-on flat blade connectors
Red LED adjacent to output terminals
"Click 'n' fit" mounting clip, fitted separately using three-hole
fixing
Limited by current sensing circuit
Limited by temperature sensing circuit
Protected by filters and rugged component selection
Protected by internal input and output fuses
2004/108/EC The general EMC directive
2006/96/EC The automotive directive
93/68/EEC The CE marking directive
CE and e marked
Power On/Off
Nominal Voltage Dimensions
24Vdc input, 217 x 87 x 62mm
24Vdc output
Weight
880g
CODE IDENT. NO. ACR PART NO.
SIZE 2686
18560
A
1:1
SCALE
Y1-03-0212H