Remote Phone Control Feature - Honeywell WAVE2EX - Ademco Two Tone Siren Installation And Setup Manual

LYNXR-I Installation and Setup Guide
System Operation
To use the defined AUX function:
To define AUX function:
AUX
To send message to pager:
To program Follow Me Announcement telephone number
Speaker Phone Operation
To place a call or answer a call using the speaker phone:
To flash (switch between two calls using call waiting):
To hang up and exit speaker phone mode:
To enable/disable (toggle) ringer:
To return the keypad to telephone mode after disarming the system:

Remote Phone Control Feature

The remote phone control feature, which must be enabled in field
system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring
count specified in field
next eight (8) seconds. During this period the panel will wait for a valid User Code to be entered. If a valid
User Code is not entered or the eight (8) second period expires a modem tone will be generated for remote
programming (Compass Downloading). If a valid User Code has been entered, the control will announce the
current system status and/or beeping sounds.
Keypad Functions
Remote Phone Control Feature
To remotely disarm system:
To remotely arm in AWAY mode:
To remotely arm in STAY mode:
To remotely arm in AWAY or STAY with no delay:
To remotely activate X10 devices 1-6:
To remotely activate X10 devices 7 & 8:
To remotely deactivate X10 devices 1-6:
To remotely deactivate X10 devices 7 & 8:
To remotely Bypass zones:
To remotely activate Forced Bypass:
To remotely check system status:
To end remote phone control session:
Press and hold
+
FUNCTION
Press and hold
AUX
OFF
[#] +
VOLUME
✻ 95, and will announce "SYSTEM ENTER CODE" every three (3) seconds for the
+ [1]
[#] + [4] + device no.
[#] + [7] + device no.
+ [6] + zone no.
[✻]
Hang Up or enter
key 2 secs (4 beeps) +
AUX
+
+ action separated by +
AUX
key 2 seconds (4 beeps)
:
[#] +
AUX
AUX
+
AUX
✻ 91, allows the user to access the security
+ [2]
+ [3]
+ [2] or [3] + [0]
+ [#] + [4] + device no.
+ [#] + [7] + device no.
+ [6] + [#]
- 52 -
terminated by +
AUX
+ + [65]
FUNCTION
NOTE
The ARMED and READY LEDs blink
alternately when the Speaker Phone is
active.
[#] +
AUX
Quick Arm Note
The installer code and
babysitter code cannot
disarm the system if
armed by Quick Arm
method.
+ [9]
+
AUX