Assembling The Fan; Or Higher) - Hunter 28790 Owner's Manual

3 • Assembling the Fan (Ceiling Must Be 9' or Higher)
3-1. Place the canopy and canopy trim ring around the adapter so that
they rest on the fan assembly.
3-2. Feed the wires from the fan through the downrod.
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the downrod.
3-3. Loosen the square head setscrew on the adapter to install the pipe
and ball assembly. Note: When the pipe and ball assembly is fully
installed, 2-3 threads on the pipe will still be visible; this is normal.
Securely retighten the setscrew with a wrench or pliers.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-4. Raise the fan and place the ball into the hanger bracket.
3-5. Align the notch on the ball with the indent in the hanger bracket.
(Rotate the fan until you hear the notch pop into place.)
Go to 4 • Wiring the Fan .
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
8
45085-01 • 09/27/11 • Hunter Fan Company
Steps 3-1 – 3-3
Adapter
Steps 3-4 – 3-5
Downrod
Canopy
Canopy
Trim
Ring
Setscrew
Indent