9 • Operating the Remote Control and Mounting the Holder....14 use a solid-state speed control with this fan. Use only Hunter speed controls, which are solid state.
Page 3
If you want to use an existing fan site, complete the following checklist to System determine if the site is acceptable and safe for your new Hunter fan. If you cannot check off every item, prepare a new fan site as described on this page.
Page 4
ANSI/NFPA 70. If your ceiling fan, go to your fan manual and continue with Section 2 • Installing the you are unfamiliar with wiring, use a Ceiling Plate. qualified electrician. 45086-01 • 09/22/2011 • Hunter Fan Company...
Page 5
Support Brace Hunter’s patented 2-position mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of two ways, depending on ceiling height and your preference: Standard or Angled mounting. The steps in this manual include instructions for Ceiling both Installer’s Choice mounting methods.
• Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. Gathering the Tools You will need the following tools for installing the fan: •...
Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten. Flat Washer Steps 2-2 – 2-4 Ceiling Peak Ceiling Peak Large Large Opening Opening 3” Screw LEFT RIGHT Step 2-3 (Angled Ceiling Only) 45086-01 • 09/22/2011 • Hunter Fan Company...
(Rotate the fan until you hear the notch pop into place.) Indent Go to 4 • Wiring the Fan. Steps 3-4 – 3-5 WARNING: Fan may fall if not assembled as directed in these installation instructions. 45086-01 • 09/22/2011 • Hunter Fan Company...
The speed of the fan should only be changed by the Hunter control. Set the ceiling fan light kit to the ON position before installation. The light level should only be changed by the Hunter control.
5-7. Position the receiver in the canopy so that the antenna is close to the edge of the ceiling plate for clear reception. 45086-01 • 09/22/2011 • Hunter Fan Company...
6-6. Twist canopy trim ring clockwise to secure the canopy. Should you need to remove the canopy trim ring: 1. Twist canopy trim ring counter clockwise until it releases from canopy. Step 6-3 Step 6-4 Canopy Step 6-5 Screw 45086-01 • 09/22/2011 • Hunter Fan Company...
7 • Assembling the Blades Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). 7-1. Your fan may include blade grommets. If your fan has grommets, Step 7-1 (Detail) insert them by hand into the holes on the blades.
9-4. You can mount the remote holder to any toggle switch plate with the screws already in the switch plate. Or, you can simply mount the remote holder on the wall. Step 9-4 45086-01 • 09/22/2011 • Hunter Fan Company...
Page 15
Clean painted and high-gloss blades in the same manner as the fan finish. In cold weather, use upward air flow pattern To Change Airflow Direction Press the reversing switch on the remote while the fan is running. 45086-01 • 09/22/2011 • Hunter Fan Company...
If you need parts or service assistance, please call 888-830-1326 (In Canada, call 866-268-1936) or visit us at our website at http://www.hunterfan.com. Hunter Fan Company 7130 Goodlett Farms Parkway #400 Memphis, Tennessee 38016 45086-01 • 09/22/2011 • Hunter Fan Company...