Table of Contents
Advertisement
v Error Log
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
Passwords
From the System Security choice, you can set, change, and delete a power-on
password and an administrator password. The System Security choice is on the
full Configuration/Setup menu only.
If you set only a power-on password, you must type the power-on password to
complete the system startup and to have access to the full Configuration/Setup
Utility menu.
54
xSeries 206m Types 8485 and 8490: User's Guide
Supervisor Adapter is installed, the full text of the error messages is
displayed; otherwise, the log contains only numeric error codes. Run the
diagnostic program to get more information about error codes that occur.
For instructions, see the diagnostic information in the Problem
Determination and Service Guide on the IBM xSeries Documentation CD.
Select Clear error logs to clear the mini-BMC system-event log.
Important: If the system-error LED on the front of the server is lit but there
are no other error indications, clear the mini-BMC system-event log. This
log does not clear itself, and if it begins to fill up, the system-error LED will
be lit. Also, after you complete a repair or correct an error, clear the
mini-BMC system-event log to turn off the system-error LED on the front of
the server.
Select this choice to view or clear error logs.
– POST Error Log
Select this choice to view the three most recent error codes and messages
that the system generated during POST. Select Clear error logs to clear the
POST error log.
– System Event/Error Log
Select this choice to view the three most recent error codes and messages
that the system generated during POST and all system status messages from
the service processor. Select Clear error logs to clear the system event/error
log.
Important: If the system-error LED on the front of the server is lit but there
are no other error indications, clear the system event/error log. This log does
not clear itself, and if it begins to fill up, the system-error LED will be lit. Also,
after you complete a repair or correct an error, clear the system event/error
log to turn off the system-error LED on the front of the server.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes that you have made in the settings, you are asked
whether you want to save the changes or exit without saving them.
Advertisement
Table of Contents
