Table of Contents
Advertisement
Configuring the Broadcom Gigabit Ethernet controller
The Ethernet controller is integrated on the system board. It provides an interface
for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provides full duplex
(FDX) capability, which enables simultaneous transmission and reception of data on
the network. If the Ethernet port in the server supports auto-negotiation, the
controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T)
and duplex mode (full-duplex or half-duplex) of the network and automatically
operates at that rate and mode.
You do not have to set any jumpers or configure the controller. However, you must
install a device driver to enable the operating system to address the controller. To
find updated information about configuring the controller, complete the following
steps.
Note: Changes are made periodically to the IBM Web site. The actual procedure
might vary slightly from what is described in this document.
1. Go to http://www.ibm.com/support/.
2. Under Search technical support, type 8485 or 8490 (depending on the machine
3. In the Additional search terms field, type ethernet, and click Go.
Updating IBM Director
If you plan to use IBM Director to manage the server, you must check for the latest
applicable IBM Director updates and interim fixes.
To install the IBM Director updates and any other applicable updates and interim
fixes, complete the following steps.
Note: Changes are made periodically to the IBM Web site. The actual procedure
might vary slightly from what is described in this document.
1. Check for the latest version of IBM Director:
2. Install the IBM Director program.
3. Download and install any applicable updates or interim fixes for the server:
66
xSeries 206m Types 8485 and 8490: User's Guide
type for your server model), and click Search.
a. Go to http://www.ibm.com/servers/eserver/xseries/systems_management/
xseries_sm/dwnl.html.
b. If the drop-down list shows a newer version of IBM Director than what
comes with the server, follow the instructions on the Web page to download
the latest version.
a. Go to http://www.ibm.com/support/.
b. Click Downloads and drivers.
c. From the Category list, select xSeries (Intel and AMD processor-based).
d. From the Sub-category list, select xSeries 206m and click Continue.
e. In the Search within results field, type director and click Search.
f. Select any applicable update or interim fix that you want to download.
g. Click the link for the executable (.exe) file to download the file, and follow
the instructions in the readme file to install the update or interim fix.
h. Repeat steps 3f and 3g for any additional updates or interim fixes that you
want to install.
Advertisement
Table of Contents
