Server Controls, Leds, And Power; Front View - IBM 206m - eServer xSeries - 8485 User Manual

Server controls, LEDs, and power

This section describes the controls and light-emitting diodes (LEDs) and how to turn
the server on and off.

Front view

The following illustration shows the controls, LEDs, and connectors on the front of
the server.
Power-on LED
Power-control button
Hard disk drive activity LED
System-error LED
USB connectors
8
xSeries 206m Types 8485 and 8490: User's Guide
When this LED is lit, it indicates that the server is turned on. When this LED
is off, it indicates that ac power is not present, or the power supply or the
LED itself has failed.
Note: If this LED is off, it does not mean that there is no electrical power in
the server. The LED might be burned out. To remove all electrical power
from the server, you must disconnect the power cords from the electrical
outlets.
Press this button to turn the server on and off manually.
When this LED is flashing, it indicates that a hard disk drive is in use.
When this amber LED is lit, it indicates that a system error has occurred.
An LED on the system board might also be lit to help isolate the error.
Detailed troubleshooting information is in the Problem Determination and
Service Guide on the IBM xSeries Documentation CD.
Connect USB devices to these connectors.
Power-on
LED
Power-control
button
Hard disk drive
activity LED
System-error
LED
USB connectors
CD-eject or
DVD-eject button
CD or DVD drive
activity LED
(Optional) Diskette-eject
button
(Optional) Diskette drive
activity LED