Table of Contents
Advertisement
1
1
power cable
CAUTION:
as the hard disk circuit board assembly is exposed here.
4 Place the computer in an upright position.
5 Remove the four screws that secure the hard drive to the hard drive bay.
6 Slide the hard drive out towards the back of the computer.
7 If removing the hard drive changes the drive configuration, ensure that you
reflect these changes in system setup (see "System Setup" on page 69).
32
Drives
2
Ensure that you do not scratch the screw holes with the screwdriver
2
data cable
3
screws (4)
3
Advertisement
Table of Contents
