Tone Timings; Busy Tone; Tone Frequencies - Panasonic KX-UT133-B Administrator's Manual

Configuration File Reference

Tone Timings

Description
Value Range
Default Value
Configuration File Reference

4.6.4.2 Busy Tone

Tone Frequencies

Description
Value Range
Default Value
Configuration File Reference
Tone Timings
Description
Value Range
Default Value
Configuration File Reference
Document Version 2011-06
DIAL_TONE1_FRQ (Page 185)
Specifies the pattern, in milliseconds, of dial tones using up to 10 whole
numbers (off 1, on 1, off 2, on 2...) separated by commas.
0–16000 (0: Infinite time)
Note
•
The unit will not play the tone for the duration of the first value,
play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100.0", the
unit will not play the tone for 100 ms, play it for 100 ms, stop it
for 100 ms, and then play it continuously.
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
60,0
DIAL_TONE1_TIMING (Page 185)
Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
480,620
BUSY_TONE_FRQ (Page 188)
Specifies the pattern, in milliseconds, of busy tones using up to 10
whole numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
0–16000 (0: Infinite time)
60,500,440
BUSY_TONE_TIMING (Page 188)
4.6.4 Tone Settings
Administrator Guide 123