En.03 Critical Condition-Power Supply Load Unbalanced; Blower Conditions; Blower Element Numbering - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

Hp storageworks 4x00/6x00/8x00 enterprise virtual array user guide (5697-8037, april 2009)
Hide thumbs Also See for StorageWorks 6100 - Enterprise Virtual Array:
Table of Contents

Advertisement

The operational power supply will automatically shut down after seven minutes, thereby disabling the
enclosure. This condition report remains active until either the problem is corrected, or the operational
power supply shuts down, whichever occurs first.
To correct this problem, record all six characters of the condition report, then contact your authorized
service representative.
CAUTION:
Removing power from an enclosure may cause the loss or corruption of data. To avoid this condition,
shut down the system using HP Command View EVA. An automatic shutdown and possible data
corruption may result if the power supply is removed before a replacement is available.
0.2.en.03 CRITICAL condition—Power supply load unbalanced
This condition report indicates that a component within a power supply may have failed. This can
make the remaining power supply a single point of failure.
This condition report remains active until corrected.
Complete the following procedure to correct this problem:
1.
Record all six characters of the condition report.
2.
Ensure that the
condition and wait one minute.
3.
Contact your authorized service representative.

Blower conditions

The format of a
0.3. is the
en. is the two-character
ec is the error code
As shown in
Figure
Figure 66 Blower element numbering
CAUTION:
A single
blower
elements for up to 100 hours. However, operating an enclosure at temperatures approaching an
overheating threshold can damage elements and may reduce the MTBF of a specific element. Immediate
replacement of the defective blower is required.
150
EMU-generated condition reports
blower
on the power supply is functioning properly. If not, correct the blower
blower
condition report is 0.3.en.ec, where:
blower
element type number
blower
element number
66,
blower
1 is in location 1 and blower 2 is in location 2.
1
operating at high speed can provide sufficient air flow to cool an enclosure and the
2
CXO7953A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents