Troubleshooting - Panasonic EW-BW30S Operating Instructions Manual

Troubleshooting

Display
The indication disappears in
is
the middle of the operation.
displayed.
(the
Pressurization to more than
280 mmHg was performed.
(Cuff pressurizes several
times.)
Pressure decreased suddenly.
is The pulse detection mark was
displayed. displayed only a few times or
not at all.
Cuff does not inflate.
Your hand or wrist moved.
is
Failure of the main unit
displayed.
Symptom
The SYS or DIA is
high.
The SYS or DIA is
low.
33
English
Status before error
mark is displayed.)
• The pressure cuff is positioned too low.
(Please see pages 14 and 15.)
• The pressure cuff is not wrapped around the
wrist properly.
(Please see pages 12 and 13.)
• The person is moving or talking when the
measurement is being carried out.
(Please see pages 14 and 15.)
• The position of the pressure cuff is too high.
(Please see pages 14 and 15.)
• The person is moving or talking when the
measurement is being carried out.
(Please see pages 14 and 15.)
Cause and solution
Batteries are exhausted.
(Please see page 9.)
Were measurements taken
according to the proper
procedure and in the
correct posture?
(Please see pages 14–16.)
Is the cuff wrapped
properly?
(Please see pages 12 and
13.)
Has the unit detected
movement?
(Please see page 24.)
Take it to the store where it
was purchased for testing
and repairs.
Possible cause