Panasonic EW-BW30S Operating Instructions Manual page 21

Pulse detection mark
4. Press the Off/On Start button.
• The display will be lit up for approx.
2 seconds.
• The cuff will begin to inflate automatically.
As measurements are being taken
during pressurization, operating sounds
and the rate of pressurization may
change. This is perfectly normal.
• The pulse detection mark will be displayed
graphically during pressurization when the
pulse is detected.
5. When measurements have been
completed, blood pressure and pulse rate
are displayed.
• Pressure will automatically be released
from the pressure cuff.
• If your blood pressure is considered to be
in the hypertensive range, then the
readings on the display will flash for
approx. 6 seconds. (Please see page 21.)
• Measurement results are also displayed as
graph. (Please see page 21.)
• The mark will be flash.
(Please pages 26 and 27 for details
regarding how to record readings.)
• The pulse is estimated over the period of a
minute based on the pulse rate recorded
when measurements were being taken.
6. Press the Off/On Start button to turn off
the unit.
• If you forget to switch the device off, it will
do so automatically after approx. 5 minutes.
20
English