Troubleshooting - Panasonic Diagnostec EW-BU1 Operating Instructions Manual

Q The mark does not light when an arm is moved.
A The mark is a function to notify you that your arm is bent or to indicate extra loads on
the cuff.
Therefore, it may not indicate motions (bending an arm slightly, etc.) that do not affect the cuff.
If you are concerned about the result, retry the measurement.

Troubleshooting

Display
The indication disappears in the
middle of the operation. (the
mark is displayed.)
is displayed.
Your arm or body moved.
Pressurization to more than
280 mmHg was performed. (Cuff
pressurizes several times.)
Pressure decreased suddenly.
is displayed.
Cuff does not inflate.
The measurement is not possible
though the cuff inflates.
Cuff pressurizes several times.
Failure of the main unit
is displayed.
Status before error Cause and solution
Batteries are exhausted. (See page 6.)
Has the unit detected movement? (See
page11.)
Were measurements taken according to
the proper procedure and in the correct
posture? (See page9.)
● Is the cuff wrapped properly?
● Is the cuff plug inserted correctly into
the socket?
(See page8.)
Take it to the store where it was purchased
for testing and repairs.
APPENDIX
18