Bios Selection And On-Line Updates - Intel SE7221BK1 User Manual

Entry server board

Hide thumbs

Table Of Contents

Table of Contents

Intel® Entry Server Board SE7221BK1-E User Guide

Type afuefi [/n] [/p[b][n][c]] <ROM filename>

/n - don't check ROM ID

/pbnc - b - Program Boot Block

n - Program NVRAM

c - Destroy System CMOS

/r - registry path to store result of operation (only for Windows version)

/k - Program non-critical block only

/q - silent execution

Wait while the BIOS files are updated. Do not power down the

system during the BIOS update process! The system will reset

automatically when the BIOS update process is completed.

Remove the diskette from the diskette drive.

1. After the BIOS updates:

2. Check to make sure the BIOS version displayed during POST is the new version as the

system reboots.

3. Enter Setup by pressing the F2 key during boot.

4. In Setup, press the F9 and <Enter> to set the parameters back to default values.

5. Re-enter the values you wrote down at the beginning of this process. Press F10 and <Enter>

to exit the BIOS Setup and Save Changes.

6. If you do not set the CMOS values back to defaults using the F9 key, the system may

function erratically.

✏

NOTE

You may encounter a CMOS Checksum error or other problem after reboot.

If this happens, shut down the system and boot it again. CMOS checksum

errors require that you enter Setup, check your settings, save your settings,

and exit Setup.